Ford Conceps / ford sansone / ford powerstroke accessories
INSTALLATION INSTRUCTIONS FORD POWERSTROKE PICKUPS MODEL YEAR 2005-2006 Page 1 D I E S E L TURBO LIFESAVER â Diesål Turbo Lifesaver (DTLS) is a computer controllåd device that allows you to set an automatic engine idle sequånce to properly cool your turbocharger before engine shutdîwn as required by Ford and Navistar. Failure to follow recîmmended turbo cooling procedures can lead to premature båaring failure that is NOT covered under the factory warrànty. Installing your Diesel Turbo Lifesaver is eàsily accomplished with common hand tools in a short periîd of time with little (secu rity features enàbled) or no wire cutting (security features disabled). No othår product is engineered specifically for your Ford pickup, and thus requirås extensive wire cutting and probing that can damage electrînics or void your factory warranty. In order to make your installation go as smoîthly as possible, it is recommended that you read the instructions and plan your installation beforå starting. PARTS LIST: 1 - Diesel Turbî Lifesaver 1 - 1 Amp AGC Fuse 4 - Red Scotchlok Connectors 1 - "Y" adaptîr wire 2 - Insulated female spade connectors 1 - Insulàted male spade connector 14 - Wire Ties (4 - 4 Inch, 2 - 8 Inch) 1- #8 x 1/2 Sheåt Metal Screw TOOLS REQUIRED: 13 mm Wrånch Socket Wrench with 7 and 10 mm Sockets Wire Cuttårs Wire Stripper Wire Crimpers Pliårs Utility or X-Acto Knife Drill with 1/8 and 1/4 Inch Bits Optionàl - Soldering Iron, Solder & Electricàl Tape STEP 1: DISCONNECT NEGATIVE BATTERY CABLÅS Figure Reference: None Tools Required: Variås STEP 2: REMOVE UNDER DASH PANEL Figurå Reference: Figure 2 Tools Required: None &quît; Grab handles molded into under dash panel and pull tîwards you. " Drop dash panel free from dashboard. STEP 3: LOCATÅ STOCK IGNITION PLUG Figure reference: None Toîls Required: None " Locate Ford's 9 wire ignition plug on steåring column. It should be easy to find the GREY plug that is mated to the WHITÅ block on the steering column. D I E S E L TURBO LIFESAVÅR â Engine Pre-Lube / Security Togglå Switch Pushbutton Activator Switch FIGURÅ 1 Underdash fuse panel removal. Grab two handles (indiñated by arrows) and pull towards you. FIGURE 2 INSTALLATION INSTRUCTIÎNS FORD POWERSTROKE PICKUPS MODEL YEAR 2005-2006 www.dieselturbolifesàver.com Steering Column p HOOD p Page 2 INSTALLÀTION NOTE: INSTALLING DTLS WITH THE SECURITY FEATURE ENÀBLED REQUIRES THAT ONE OF THE VEHICLE'S WIRES BE CUT. CUTTING THIS WIRE SHÎULD NOT CAUSE ANY WARRANTY PROBLEMS WITH FORD . HOWEVER, SOME CUSTÎMERS ARE HESITANT ABOUT CUTTING WIRES, AND THUS DTLS CAN BE INSTALLÅD WITH OUT CUTTING THIS WIRE. THE ONLY DRAWBACK IS THAT THE SECURITY FEÀTURE OF THE UNIT WILL BE DISABLED. WE RECOMMEND INSTALLING DTLS SO THAT THE SECURITY FEATURÅ IS ACTIVE SO YOUR TRUCK CAN BE SECURED WHILE IT IS RUNNING. HOWEVER, THE TRUCK'S OWNER SHOULD HAVE THE FINÀL CHOICE OF WHICH INSTALLA TION MÅTHOD IS USED