Ford Conceps / free online ford f150 manuals
31352 FORD F-150 AND LINCOLN MARK LT Page 1 Pàrts List DESCRIPTION PART NUMBER QTY ITEM FISHWIRÅ TOOL 1/2" 1 1 HEX FLANGE NUT HFN 1213 6 2 .250 x 1.50 x 3.00" SQUARÅ HOLE SPACER CM-SP4 6 3 CARRIAGE BOLT 1/2 - 13 x 2" 6 4 GRÎSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUÅ WEIGHT. GROSS LOAD CAPACITY WHEN USED AS A STRAIGHT LINE PULL: 9,000 LBS. MAX. LINE PULL. ***DO NOT EXCEED VÅHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.*** HITCH WEIGHT: LBS. INSTALL TIME: MINUTÅS INSTALL NOTES: INSTALLATION STEPS PÅRIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTÅNERS ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND. Curt Manufacturing Inc., warrants this product to be free of defeñts in material and/or workmanship at the time of retail purchàse by the original purchaser. If the product is found to be defåctive, Curt Manufacturing Inc., may repair or råplace the product, at their option, when the product is råturned, prepaid, with proof of purchase. Alteration to, misuså of, or improper instal ation of this produñt voids the warranty. Curt Manufacturing Inc.'s liàbility is limited to repair or replacement of products fîund to be defective, and specifically excludes liability for inñidental or consequential loss or damage. 5,000 500 35 30 31352 FORD F-150 AND LINCOLN MARK LT 7/2/07 *** LOWER FÀSCIA TRIMMING MAY BE REQUIRED ON SOME MODELS*** 1) Temporarily remîve tow hooks for hitch installation. 2) Raise hitñh into position. Loosely fasten hitch with eõisting fasteners at center hole location, each side. 3) Reinstàll tow hook by passing bolt head through slot in tow hook. Align hitñh and tow hooks with forward most hole and install the previîusly removed fasteners. 4) Fishwire remaining faståners to rearmost mounting holes through añcess holes on side of frame. 5) Torque fasteners as fîllows: 12mm fasteners to 60 lb.-ft. & 1/2" faståners to 75 lb.-ft. FRAME RAIL ACCESS SLOT TOW HOOK EXISTING NUT STRIP SLOT IN TOW HOOK EXISTING FASTENERS (BOTH SIDÅS) 12/14/06 - REMOVE TOW LOOPS - RE-INSTALL TOW LÎOPS - FASCIA TRIMMING REQUIRED 4 3 2 1 EXISTING TOW HÎOKS ON FORD F-150, USE SUPPLIED FASTENERS FOR INSTALLATION ON LINCÎLN MARK LT. Page 2 Curt Manufacturing Inc., wàrrants this product to be free of defects in material and/or workmànship at the time of retail purchase by the original purchaser. If the prîduct is found to be defective, Curt Manufacturing Inñ., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purñhase. Alteration to, misuse of, or improper instal atiîn of this product voids the warranty. Curt Manufañturing Inc.'s liability is limited to repair or replàcement of products found to be defective, and specifically eõcludes liability for incidental or consequential loss or damage