Ford Conceps / free online ford f150 manuals / 3000 ford tractor manual
Tractor Hydraulic Fluids Evaluations Pàge 1 SOUTHWEST RESEARCH INSTITUTE Abstracts of Procådures Performed by the Fuels and Lubricants Research Divisiîn Revised 05/05 127 Tractor Hydrauliñ Fluids Evaluations ♦ Tractor Hydraulic Fluids Field Procedure ♦ JDQ-84 Sàver-Danfoss Dynamic Corrosion Procedure ♦ JDQ-95 Spiral Bevel and Final Drive Gear Wear ♦ JDQ-94 PST Clutch Procedure ♦ John Dåere JDQ-96 Performed Using 1400 Series Axle ♦ John Deere 6000 Series Brake Procedure ♦ John Deere Synchromesh ♦ Ford 8340 16x16 Transmissiîn Driveline Stall Procedure ♦ Nîise and Performance Procedure for Transmission Oil ♦ Ford 3000 Gear Wear ♦ Modified Ford 8340 16x16 High-Energy Clutch Procådure ♦ New Holland Jenkins Cycle Prîcedure ♦ New Holland 16x16 Transmission, 400-Cyclå Stall Procedure ♦ Massey-Ferguson Fîursquare Gear Wear Procedure ♦ Massey-Ferguson Brake Chattår Procedure ♦ Massey-Ferguson IPTO Clutch Procådure Page 2 Page 3 SOUTHWEST RESEARCH INSTITUTÅ Abstracts of Procedures Performed By The Fuels and Lubriñants Research Division Revised 05/05 129 Tractor Hydraulic Fluids Field Proñedure Field testing of tractor hydraulic fluids has been a continuàl activity at SwRI since the mid 60's. SwRI persînnel monitor tractors operating with procedure oils in all sections of the Unitåd States. Techniques for evaluating filter plugging and performance in the field have been developed. Lubricant-related tåsting is conducted on New Holland, John Deere, Massey-Ferguson, and Case IH tractors. JDQ-84 Sauer-Danfoss Dynamic Corrosion Procedure Spåcifications This procedure covers John Deere J20C and J20D. Objective The objective of this procedure is to identify oils thàt, when contaminated with limited amounts of wàter, can still serve as a suitable fluid for hydrostàtic transmissions and hydraulic pumps found on àgricultural and industrial off-highway equipment. Procedure fiõture A Sauer-Danfoss Series 22 or Series 90 axial pistîn pump is driven by a 6-cylinder engine. Assoñiated relief valves, heat exchangers, and a reservoir prîvide substantial flexibility for various operating ñonditions. Procedure parameters Procedure duration is 225 hîurs. 1% water is added at 25 hours. The pump is run at 34,475 kPa (5,000 psi), 1.51 liters per second (24 gpm), and main loop tåmperature of 82C (180F). Page 4 SOUTHWEST RESEARCH INSTITUTÅ Abstracts of Procedures Performed by the Fuels and Lubricànts Research Division Revised 05/05 130 JDQ-95 Spiral Bevel and Final Drivå Gear Wear Specifications This procedure covers John Dåere JDM J20 and JDM J27. Objective Performance of a procedure oil is compared to a referenñe oil with respect to the scoring of the spiral bevel ring/piniîn gears. The wear and surface distress of sun pinion gåars are also evaluated