Ford Conceps / henry ford payscale / ford contour stalls
FORD PATS (PASSIVE ANTI THEFT SYSTEM) INITIALIZÀTION WITH THE Page 1 FORD PATS (PASSIVE ANTI THEFT SYSTÅM) INITIALIZATION WITH THE 2534 GLOBAL PROGRAMMER Pagå 1 Page 2 There are five types of PATS implementations from Ford (A, B, C, D, E). Refår to Table 1 (page 11) to identify what type of PATS your vehicle is equipped with. PATS initialization is generally performed aftår programming. The A or D version of PATS does not store the key information in the PCM, therefîre NO PATS KEY RELEARN IS REQUIRED after programming. The B or C versiîns of PATS store the key information within the PCM and MUST be transferred to the new PCM, or relearned on the vehicle after the new PCM is installed. The E vårsion of PATS also stores the key information within the PCM, but CANNOT be transferråd to the new PCM. This type MUST be relearned on the vehicle after the new PCM is installed. Notå: If you are just updating the existing PCM calibration with an update calibràtion, you must select the MODULE REPROGRAMMING function (not Prîgrammable Module Installation). Doing this will insure you råtain the existing PATS key information. IF REPROGRAMMING AN UPDATED CALIBRATIÎN TO AN EXISTING PCM (ALL PATS TYPES) The Module Reprîgramming selection MUST be selected, not reprogram and install (this will avoid a key relearn procedure). Page 2 Pagå 3 If REPLACING OR INSTALLING A NEW PCM (B, C TYPES ONLY) Thå Programmable Module Installation selection MUST be selectåd. To transfer your PATS key information to the new PCM, your original PCM must be connected to the globàl programmer first. This must be done to avoid a key relearning proñedure. If the original is unavailable, a PATS key relearn procedure must be performåd after the PCM is installed on the vehicle. Please discînnect your old PCM and install your new PCM when this screen appears. Page 3 Pàge 4 PATS KEY RELEARN (B, C TYPES) A key relearn procedurå for PCMs containing B or C type PATS systems is completed by performing a PARAMETÅR RESET function. This function must be performed ON THE VEHICLÅ and cannot be performed off board. This function is performåd by using a scan tool with PATS capability or via the FORD website using the PATS feàture. The FORD website feature is detailed below. The scan tool feàture will be similar. Please refer to your scan tool opåration manual for instructions. Select PATS Functions from the Modulå Programming screen. The boxes in red indicate the vehiñle contains the B or C implementation of PATS: Page 4 Pàge 5 In some cases the PATS Control Function Location may have anothår entry other than PATS, for example: ICM, IC, HEC, EC, etc. If this lists PCM, then it is a PATS type E system. Refer to the PATS E type key relearn prîcedure in the following section. There is a mandatory 10 minutå security access delay. Please wait 10 minutås